3. Best Practices

Some suggestions on how to model properly the cure cycle are given in the following sections:

• Reccomended Analysis Settings For ACCS RTM Solver

3.1. Reccomended Analysis Settings For ACCS RTM Solver

3.1.1. Result Step Increments

For larger models, it is reccomended to set the result step increment to a large value (e.g. 10-50). This is to reduce the size of the output file.

3.1.2. Overfill

The overfill factor should be set to 1. The higher the overfill factor, the less accurate the simulation will be. However, it will make the model run faster.